|
Thanks, we like it! [8)] I am actually going to really spoil it for you then. I have run the supply lines on 8" center each 4" from and raised 2 1/2" above the drain line. I am looking for some small 5 spoke handles to replace the silver stock handles. I will use some rigid OD to span up to the faucet. I think it will make for a classic look.
I really would like to get this figured out. It seems like I can sweat the 1 1/4 Ptrap drain pipe into the 1 1/4 drain and just ue enough solder. Please someone tell me that is incorrect if it is!
I just do not understand (due to lack of knowledge) why the two are so differently sized......
|