[bigrick7]

I have a water filled baseboard system for home heating. I have two valve controls (Honeywell) not wired yet. one for the upper zone and one for the lower zone. both valve are in the open position. each valve has 2 red and 2 yellow wires not yet connected. I have two programmable thermostats already wired with 2 wires red and yellow. one in the upper level of my house one in the lower level. Right now only the lower level is connected to the system. what I would like to do is finish wiring the system for 2 independant zones. There is a transformer (Honeywell Control Circuit Transformer) for the system in place but not wired yet to the boiler or thermostat but it is powered (wired) by 110 volt. Right now there is a wire coming from my programmable thermostat (red and yellow) that connects to a wire from my williamson gas boiler (red and yellow), the heating system is currently working but as 1 zone. what must I do to finish wiring for a 2 zone system. the wiring for the 2nd programmable thermostat is all ready here next to the transformer it is just not hooked up to anything. I need step by step help, thank you for any help you can give me.