[clifford]

Hi..I laminated a counter top yesterday, and while routing the edge with a laminate trimmer, I didn't keep the base plate firmly flat on the horizontal material, and took off some of the color on the vertical edge. In one spot, it was just that, taking off some of the color, but in another, I managed to gouge the vertical edge. Any tricks of the trade to fall back on. I guess I could remove the edge, and redo it, but that presents a whole range of problems with the horizontal surface. I looked on the Wilson Art page, but found no repair kits, etc. Any ideas? I'm sure I'm not the first, nor will be the last to do this. I was tired, and rushed the job, which is a lesson in itself. Thanks, Clifford