12-20-2007, 04:58 PM
|
 |
Deity
|
|
Join Date: Jul 2004
Location: Saint Regis Falls, NY, USA.
Posts: 3,401
|
|
|
did you use a straight cutter for trimming the edge? did the bit have a ball bearing on its end? when you make a cut the bit should be down about 3/8 of an inch with the ball bearing drive. if you've installed the countertop and the edge look into a 37 degree or 45 degree ball bearing bit. once everything is glued up and dry use the 45 or 37 degree bit to gently round over the sharp corner.
|