|
Ohh, ok. Yea, I check what you mentioned and earlier today I removed that valve switch assembly. I shook it over my sink for little and installed it back in. No dripping after filling a glass. Did this 5-6 times, and no dripping. Normally as soon as I'd fill a glass, within 10 seconds it would drip. BUT, 3 hours later when I tried using it again, it's now dripping after filling a glass. Argh.
Also, I just did some more digging and was told this:
"low pressure will stop the valves from opening but not closing. The valves are shut by a spring plunger assembly in the selonoid, so replace the valves".
I think this may be the case. I'm assuming when I replace the valves that spring plunger assembly is built inside that valve part too?
|