Quote:
|
Originally Posted by Joan6009
the 'screws' actually don't have a place for a screwdriver. it looks like a nut without a hole in the middle. As you can hopefully see from the photo
|
Your picture shows 1/4" hex head screws (see image below). They are very common in the appliance industry.
Those need a "nut driver" or a screwdriver with interchangeable bits (see the following link). On the latter, just use the screwdriver without a bit installed in its shaft.
LINK >
6 in 1 Screwdriver
Once loosened just a bit, the icemaker can be lifted slightly and then off the screw heads to remove it.
JFYI
Dan O.
www.Appliance411.com
The Appliance Information Site
=D~~~~~~