Thanks to all who posted replies to my question. This is a great forum to get help so quick. Here are a few answers to the follow-up questions that were posed.
- I would have posted a sketch yesterday but for some reason the system wouldn't accept my sketch. However it did today so hopefully this will add more clarity.
- You will see that I am using 2 inch pipe to allow myself the 3.5ft run between the vent and the wet bar sink.
- I'm tying this into a rough-in that the builder left in my home.
- Yes, I am aware of the 1/4 pitch for horizontal pipe runs and have that planned in.
- You can see how I am venting the system. Should be OK.
- My current plan was to use a 2" long sweep 1/4 bend on the wet bar sink connection and use a reducer to connect to a 1-1/2" P-trap. On the vanity sink I was planning a 2"x2"x1-1/2 tee-wye and an eighth bend to connect the 1-1/2" p-trap into. However standard fittings make for a nicer fit through the wall which is why I posted the question.
- As for Redwood's question I was planning on using 1/4 bend #304 vs #300.
Thanks for the help.
Fred