[loosescrew]

Hello everyone,

I am going to attempt a DIY repair of the 1 x 12 section of my driveway which connects my garage floor to an aggregate drive. There is approx a 2-foot section which started out as large cracks, and I have since chiseled away all the loose material leaving a "pothole". This hole is 2 1/2" at it's deepest point, and approx 1 1/2" deep at the most shallow point.

I have attached some pics which should explain my repair in much better detail. My questions are:

1. What type of concrete mix should I use?
2. Are there tricks to edging the patch so that it matches the surrounding material?
3. Is resurfacing the entire 1' x 12' area after the initial patch is cured the best bet to make for a cosmetically pleasing result?

Any advice would be greatly appreciated!

Ben