11-05-2009, 08:58 AM
|
|
 |
Deity
|
|
Join Date: Jul 2004
Location: Saint Regis Falls, NY, USA.
Posts: 5,307
Thanks: 0
Thanked 148 Times in 143 Posts
|
|
|
that flat cable connector your pix shows isn't meant to keep the wire from sliding into the appliance, it is supposed to keep the wire from moving out of the range. you have pictured one-half of a ninety degree elbow fitting. this fitting should be removed. the ears of the flat cable connector go inside the wiring box, the cable slips into the connector. the two screws tighten on the cable. the rest of the connections are just as you have them connected [only exception is there's no jumper between the center and green ground] which there should be.
|