Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Blog Blogs Groups Groups
  • hawkins111's Avatar
    Today, 12:11 PM
    The 422 does have a inner piece for the nozzle port, it doesn't stick out into the center of the burner. That piece has to be installed or the brass...
    1 replies | 30 view(s)
  • ctbale's Avatar
    Today, 04:11 AM
    So last year I rebuilt a friends 2 heaters. A 2200 and a 422 The question I have is I noticed that the 422's Burn Pot did not have an extension...
    1 replies | 30 view(s)
  • ctbale's Avatar
    Today, 02:41 AM
    ctbale replied to a thread E01 in Monitor Heaters
    Wire was good. I pulled the connector off the mother board. At first it cleared the E1 fault, plugged it back in and it ran for a while then came...
    9 replies | 2187 view(s)
  • rrob311's Avatar
    Yesterday, 08:10 PM
    I went through the burn chamber on my spare m21 heater and test fired it earlier. It worked ok so I shut it down. Went to fire it back up and it went...
    0 replies | 31 view(s)
  • FordMan59's Avatar
    Yesterday, 02:10 PM
    FordMan59 replied to a thread E01 in Monitor Heaters
    If it's a main board check eBay often there will people selling used ones at a fraction the cost of a new one. I bought a spare one for my 422's in...
    9 replies | 2187 view(s)
  • ctbale's Avatar
    Yesterday, 02:59 AM
    ctbale replied to a thread E01 in Monitor Heaters
    Working on two 422s One of mine has the E1 code also. Book says like above post says flame rod or wire is grounding. Will investigate that...
    9 replies | 2187 view(s)
  • mrcaptainbob's Avatar
    11-23-2018, 10:47 PM
    Don't need it anymore. Will use copper and a couple of 90* Sharkbites.
    1 replies | 208 view(s)
  • mrcaptainbob's Avatar
    11-21-2018, 06:01 PM
    I'd like to connect the water softener (1" inlet/outlet) to the house water system (1" copper) using 1" braided stainless. Or braided anything....
    1 replies | 208 view(s)
  • mrcaptainbob's Avatar
    11-20-2018, 01:38 PM
    It's been awhile. The water from the new well isn't bad at all. BUt I have been getting 'complaints' lately. Ordered a Fleck with metered head....
    5 replies | 1811 view(s)
  • hawkins111's Avatar
    11-14-2018, 01:24 PM
    The Toyo blower is a dual function unit. It sucks air in on the bottom fan and blows exhaust out by the top fan. The Toyo combustion system is not...
    4 replies | 504 view(s)
  • rrob311's Avatar
    11-13-2018, 08:16 PM
    Is there an easy way to clean it? Do I remove the blower? How would it get carbon in it? Isn't it just drawing in outside air?
    4 replies | 504 view(s)
No More Results