I don't know. Maybe I said the wrong thing. Here are some pics.

Figured as much, at least common sense would say so. Apparently the person who lived here before me didn't have too much of it. Alright then, I guess...

I looked into the 636 piping system. it is pvc and cpvc - poly vinyl chloride - the white stuff with a high operating temperature of 90 degrees C....

since the discoloration is mildew, not mold, I'd opt to spraying it with clorox bleach.

rust on water heater valves? are you sure? most valves or rather all valves are red bronze or red brass valves. I don't know where he's coming up...

ANY furnace should be on its own dedicated "hard wired" circuit. for a local disconnect use a T rated 20 amp toggle switch. no harm would be there...

Adding to my above question, is it safe to take the cover off the electrical panel? It looks like its just 4 screws that hold it on, I am just unsure...

I'm going to try the "hose blaster", which is a nozzle with a soap reservoir. It was a soap shutoff, so that will minimize the amount of things I...

Thanks. I have the primer, so hopefully that helps. I have noticed that after I have them assembled and take them apart that they go back together a...

sorry, this is a little late, but - find out the wattage of the lamp and divide it by the voltage applied, you'll get the total amps.

you might use a primer/cleaner on the fittings and ends of the pipe. its basically acetone and it softens plastic. the cement should have particles...

I have been working on this again today. I am now wondering if the piping and fittings need to bottom out in each other, or should they just be...

Are these bearings ball bearings or sleeve bearings? Ball bearings should have to be driven onto the shaft. Sleeve bearings are normally not...