Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Blog Blogs Groups Groups
Filter by: Forums Clear All
  • paulmars's Avatar
    Today, 06:18 PM
    I just bought a new thermostat for my central oil HVAC unit. Honeywell TH4110D. I can set it for oil heater <90% efficiency or >90% efficiency. I'm...
    0 replies | 5 view(s)
  • paulmars's Avatar
    Today, 04:30 PM
    paulmars replied to a thread manometer accuracy in HVAC
    great tip. that would be more accurate. I asked dwyer and they just suggested their 400$ digital high range unit that was not any more accurate. I...
    2 replies | 72 view(s)
  • adnadeau's Avatar
    02-13-2018, 08:39 AM
    adnadeau replied to a thread manometer accuracy in HVAC
    You're on the right track, except +/-1.5% = 0.015 x 4" = 0.06" wc. I suggest you look at instruments with a full scale deflection closer to what you...
    2 replies | 72 view(s)
  • paulmars's Avatar
    02-12-2018, 11:24 PM
    paulmars started a thread manometer accuracy in HVAC
    What is a good reasonable priced accurate manometer to measure my barometric damper? My furnace should be 0.025 and my flue should be -0.02....
    2 replies | 72 view(s)
  • FordMan59's Avatar
    02-09-2018, 08:11 PM
    FordMan59 replied to a thread fifth wire in HVAC
    Most thermostats can be used with systems that have a different number of wires. Check the user guide that came with the thermostat it's likely it...
    1 replies | 67 view(s)
  • paulmars's Avatar
    02-09-2018, 06:02 PM
    paulmars started a thread fifth wire in HVAC
    My HVAC thermostat is 4 wire system W,R,Y,G. I just bought a new thermostat that uses 5 wires, w/extra Common connection. I was considering running a...
    1 replies | 67 view(s)
  • FordMan59's Avatar
    02-04-2018, 05:20 PM
    FordMan59 replied to a thread 422 Flame Sensor in Monitor Heaters
    HHG never had their Monitor parts listed on their web site but if you'll call the number they have listed on their web site and tell them what you're...
    2 replies | 234 view(s)
  • hawkins111's Avatar
    02-04-2018, 11:13 AM
    Whats going on with Hickory Home and Gardens and Monitor parts? I dont see anything on their website about Monitor.
    2 replies | 234 view(s)
  • FordMan59's Avatar
    02-02-2018, 10:27 PM
    Anyone got a 422 flame sensor they want to sell cheap (new or used)? I was able to pick up an extra burn chamber minus the igniter and flame rod. I...
    2 replies | 234 view(s)
  • msearcher's Avatar
    01-26-2018, 08:54 PM
    FYI The customer said they had run for 10 years on #2 low sulfur on an out side tank without any service??
    8 replies | 764 view(s)
  • hawkins111's Avatar
    01-25-2018, 08:16 PM
    Yes Sir Re, that will do it. Big mess. Thanks for the up date.
    8 replies | 764 view(s)
  • msearcher's Avatar
    01-25-2018, 07:36 PM
    After servicing the second heater a second time I found out the customer was burning #2 low sulfur heating fuel!!!! thanks everyone for your...
    8 replies | 764 view(s)
  • hawkins111's Avatar
    01-23-2018, 04:39 PM
    Start your stove and look at the flame. If the flame is strong and the stove shuts down you have something going on with the flame sensor, i.e. soot...
    8 replies | 764 view(s)
  • msearcher's Avatar
    01-23-2018, 03:11 PM
    Stove and kero tank filters are fine
    8 replies | 764 view(s)
  • FordMan59's Avatar
    01-23-2018, 08:52 AM
    Usually when I have that problem cleaning the filter solves the problem.
    8 replies | 764 view(s)
  • msearcher's Avatar
    01-22-2018, 11:12 PM
    New factory burn pot, new burn ring, combustion and circulation bearings, damper o-ring, carb & filter cleaned. carbon removed from heat...
    8 replies | 764 view(s)
  • hawkins111's Avatar
    01-22-2018, 09:50 PM
    What was done at the full service? How long does the heater run after you reset it?
    8 replies | 764 view(s)
  • mrcaptainbob's Avatar
    01-22-2018, 09:45 PM
    GenerLink 40 Amp Meter Mounted Transfer Switch I LIKE IT!! But have not checked with Consumer's to see if they'll accept it's use. WIll check...
    0 replies | 126 view(s)
No More Results