Activity Stream

Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Blog Blogs Groups Groups
  • vipmaint70's Avatar
    10-17-2018, 01:49 PM
    vipmaint70 replied to a thread Burner Pots in Monitor Heaters
    i actually found a guy that repaired them for me and i have since used them all...i can order new through carswell in nc but they aren't cheap now. ...
    9 replies | 1903 view(s)
  • woodauger's Avatar
    10-08-2018, 09:04 AM
    Thanks for the reply, i should have been more patient. It straightened out by itself and burns perfectly. Now back to the firewood pile
    2 replies | 249 view(s)
  • hawkins111's Avatar
    10-06-2018, 10:21 AM
    Do you have the Air Damper S part # 6209 installed in the air hose? If not you are getting too much air.
    2 replies | 249 view(s)
  • woodauger's Avatar
    10-05-2018, 05:44 PM
    I just renewed a 422 burner pot with advice from this site, including mat and gaskets. The ring was in good shape and reused. The heater starts...
    2 replies | 249 view(s)
  • FordMan59's Avatar
    09-28-2018, 12:52 PM
    I would expect low/medium to use less power than high. I know that's the way it works with things like hand held hair driers and crock pots. If...
    2 replies | 555 view(s)
  • rrob311's Avatar
    09-25-2018, 02:54 PM
    rrob311 replied to a thread Burner Pots in Monitor Heaters
    Vip do you have a burner pot for a 41 that you would like to sell? I would like to fix one of my heaters with a bad pot. I have an idea for the pins...
    9 replies | 1903 view(s)
  • HayZee518's Avatar
    09-22-2018, 05:13 PM
    check the heating pad. there should be something printed on it. look for watts. divide watts by 120 to get amps. but watts is what's measured on a...
    2 replies | 555 view(s)
  • tperk100's Avatar
    09-20-2018, 03:21 AM
    Air Handler Fan Motor was the problem. It finally crapped out totally. Contractor quoted $650 to repair. I did it myself. Cost $65 for motor and...
    9 replies | 2085 view(s)
  • tperk100's Avatar
    09-20-2018, 03:14 AM
    Reversing Valve was Sticking. Amana replaced entire system this past winter with 18 SEER THREE ton (From 4). I did a manual J and MADE them put 3...
    11 replies | 3436 view(s)
  • tperk100's Avatar
    09-20-2018, 02:58 AM
    Have 18 ft Door with Liftmaster 2220 Opener and 888LM Wall Control, 890MAX Remotes. When closing door from either wall control or remote control,...
    0 replies | 145 view(s)
No More Results