 |
 |
|
 |

08-31-2008, 06:35 PM
|
|
|
New Member
|
|
Join Date: Aug 2008
Posts: 2
|
|
|
Mistake on wood kitchen countertop
My boyfriend and I were cutting our kitchen countertop and had a problem with the saw. The counter edge is now jagged, and if we sand it down to where it would be perfect, it would be too short. Is there any sort of edge or cap that can be put on that would mask the error, or do we have to start all over again? Any tips, tricks, and suggestions would be greatly appreciated. Thanks.
|

08-31-2008, 07:34 PM
|
|
|
Handyman
|
|
Join Date: Jan 2006
Location: Washington D.C.
Posts: 29
|
|
|
Does the end of the counter butt to a wall? If so, could you use a side splash to cover the edge of the counter? That would compensate for 3/4". If you can get one that hooks over the front of the counter that would cover everything. Otherwise you would have to caulk the front of the counter to the wall. If you can use a splash on each side you could compensate for an inch and half.
Tell us exactly how the top is situated and maybe we can come up with something for you.
Next time, clamp a straight edge on the counter to guide your circular saw.
|

08-31-2008, 07:40 PM
|
|
|
New Member
|
|
Join Date: Aug 2008
Posts: 2
|
|
|
Where the counters are situated
Unfortunately, the problem side is against the stove or against the wide open air. No wall area to hide it against.
|

09-02-2008, 05:50 PM
|
|
|
Handyman
|
|
Join Date: Jan 2006
Location: Washington D.C.
Posts: 29
|
|
|
I have seen an end cap that bridges the gap between the stove and the edge of the counter. It's used to keep things from falling between the stove and counter. I don't know how much it will cover. I'm not even sure where to buy one of these. Maybe in the housewares section of a department store. That's the only thing I can think of that has a chance to easily fix your problem.
|

09-03-2008, 11:03 AM
|
|
|
 |
Deity
|
|
Join Date: Jul 2004
Location: Saint Regis Falls, NY, USA.
Posts: 3,837
|
|
|
I don't know if you can still find it but there WAS a chrome cap that you could put along the edge of a counter. another alternative would be to find a matching countertop piece laminate plus the substrate - and trace the outline of the counter top then use a router with a shallow veining bit and cut into and trace within the tracing and make a cap out of that. the outside of the cap you could glue some laminate to hide the end grain.
|
 |
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
| Thread Tools |
|
|
| Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Stats |
Members: 10,154
Threads: 6,798
Posts: 28,096
Top Poster: HayZee518 (3,837)
|
| Welcome to our newest member, The zzz Man |
» Links |
|
» Online Users: 31 |
| 0 members and 31 guests |
| No Members online |
| Most users ever online was 388, 07-01-2007 at 02:54 AM. |
|
All times are GMT -5. The time now is 01:20 AM.