Incandesant lights on fiber-plastic ceiling tile
I recently purchased new fiberglass-plastic drop ceiling tiles to
replace old tiles in the basement. When replacing the tiles I found
that the old heavy 6" recessed lights were just resting on the tiles.
I knew these lights were too heavy for the new tiles. So I went back to the store and purchased 4" halo NON-IC and halogen bulbs PAR20 on the salesmans recommendation. I asked if they put off too much heat for the drop ceiling. He said they were shielded and wouldnt be a problem. So I have now installed 10 lights and I am paranoid.
I checked the manufacturer websites again and the ceiling tile manufacturer has a very small blurb that incandesant lights are too hot for fiber-plastic tiles. I was not surprised just very annoyed as I don't have a solution and I am not sure there is a risk.
I did a sanity check and I checked after an hour's use and the canister was hot to the touch, not super hot at the bottom - can hold finger there. It seems that the inserted cone is providing shielding the bottom. I can't be sure that it is transfering heat to the tile.
My questions are
Is it safe? and a second dumb question. Am I going to have code problems?
thanks
Linear Mode
