Home Repair Forum



Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 04-19-2006, 08:04 PM
New Member
 
Join Date: Apr 2006
Location: the woodlands,texas
Posts: 4
teecee is on a distinguished road
Unhappy teecee

Just had new compressor installed outside house.technician says inside and outside coils need to be chemically cleaned as well as inside blower(fan).
Being on a fixed income (a/c company wants over $500.00 to do this),
can someone tell me where to get chemical cleaner and instruct me as to how to properly do the job.Guess i should have been more specific...by "inside" i mean the coil and blower located inside the house as well as outside coil.

Last edited by teecee; 04-19-2006 at 10:13 PM.
Reply With Quote
  #2 (permalink)  
Old 04-19-2006, 08:32 PM
pushkins's Avatar
Handy, Man
 
Join Date: Mar 2006
Location: North Carolina
Posts: 496
pushkins is on a distinguished road
If your talking about an air conditioner compressor with I assume you are , then there should be no real need to "clean" anything. As long as you keep the leaves etc... away from the compressor it should be right to go.
I would be very wary of any company that tells you you need a $500 cleaning on a NEW compressor.

First time I've ever heard that one !!!!!!!
Reply With Quote
  #3 (permalink)  
Old 04-19-2006, 09:51 PM
New Member
 
Join Date: Apr 2006
Location: the woodlands,texas
Posts: 4
teecee is on a distinguished road
teecee

guess i wasn't very clear...it's the a/c coil and blower inside the house that needs cleaning.sorry for misleading.
Reply With Quote
  #4 (permalink)  
Old 04-19-2006, 10:49 PM
pushkins's Avatar
Handy, Man
 
Join Date: Mar 2006
Location: North Carolina
Posts: 496
pushkins is on a distinguished road
Did you not say that this unit is new ? New should mean there is a warranty.

If that is the case, it at worst will be due a "service call" in a year and that shouldn't even come close to $500. Most HVAC companies will offer a service call/general maintenance call for around $100.
As for a "chemical cleaning of the coils" on a new, a newish unit or even an older unit, it would be the first I've seen.
Most AC units are installed and forgotten (maintenance wise) for years and seldom have problems, your "blower" is part of your heating/furnace system and will be serviced with any furnace service agreement you might have.
I've had my HVAC guy install a great many HVAC systems over the years and never have we had the need to chemical clean anything, new or old.
Reply With Quote
  #5 (permalink)  
Old 04-20-2006, 12:09 AM
Handyman
 
Join Date: Apr 2006
Location: Roanoke, Texas
Posts: 24
skintdigit is on a distinguished road
Hi Teecee,
Sounds like you had a compressor failure and the A/c repair folks replaced just the compressor in an existing unit. If the furnace/A/C filters have not been changed regularly or if the system was operated for a time without filters, then you may have a clogged evaporator coil(that's the one inside the house...the cold one). Home improvement stores carry aerosol coil cleaner in the ventilation area...probably in or near the same aisle in which you'd find furnace filters. The stuff comes out of the can nozzle and then foams up to expand into the small gaps in between the coil fins. To clean the evaporator coil, turn off the circuit breakers that power the HVAC system, then find the sheet metal screws that hold the ductwork in place around the "upwind" side of the evaporator coil. You can find the coil by looking for the part of the A/C system that has the large and small copper tubes running into it from the compressor/fan assembly outside. There will also be a plastic(PVC) drain line leading away from the coil. This takes the water, which condenses on the coil and runs off into a catch pan, to a drain or outside the structure. Remove enough screws to get to the coil face...it will look a bit like a car radiator, with fins and tubing. If the coil face is clean, button it back up. If the coil fins are clogged with gray/black linty funk, then blast it off as best you can with a couple of cans of coil cleaner, give it a quick rinse if you wish, make sure the PVC drain line is clear, then put it together again and remember to always keep a clean filter in place so you won't have to deal with sharp sheet metal in your attic again. Clean the outside(condenser) coil the same way, SHUT THE BREAKERS OFF OR PULL THE SERVICE DISCONNECT BEFORE YOU CLEAN THE CONDENSER COIL. You will not like the new hairstyle that 240 volts can give you. Hose the condenser coil off spraying inside-out if you can, let it dry a bit, then reenergize the circuits. You might also find a commercial coil cleaner that is sold as a concentrate that you put into a pump-type garden sprayer. That'll do fine, as well. Some of these cleaners contain mild acids, so use them with care. Hope that helps!
Reply With Quote
  #6 (permalink)  
Old 04-20-2006, 12:15 AM
Handyman
 
Join Date: Apr 2006
Location: Roanoke, Texas
Posts: 24
skintdigit is on a distinguished road
Hi Teecee,
Sounds like you had a compressor failure and the A/c repair folks replaced just the compressor in an existing unit. If the furnace/A/C filters have not been changed regularly or if the system was operated for a time without filters, then you may have a clogged evaporator coil(that's the one inside the house...the cold one). Home improvement stores carry aerosol coil cleaner in the ventilation area...probably in or near the same aisle in which you'd find furnace filters. The stuff comes out of the can nozzle and then foams up to expand into the small gaps in between the coil fins. To clean the evaporator coil, turn off the circuit breakers that power the HVAC system, then find the sheet metal screws that hold the ductwork in place around the "upwind" side of the evaporator coil. You can find the coil by looking for the part of the A/C system that has the large and small copper tubes running into it from the compressor/fan assembly outside. There will also be a plastic(PVC) drain line leading away from the coil. This takes the water, which condenses on the coil and runs off into a catch pan, to a drain or outside the structure. Remove enough screws to get to the coil face...it will look a bit like a car radiator, with fins and tubing. If the coil face is clean, button it back up. If the coil fins are clogged with gray/black linty funk, then blast it off as best you can with a couple of cans of coil cleaner, give it a quick rinse if you wish, make sure the PVC drain line is clear, then put it together again and remember to always keep a clean filter in place so you won't have to deal with sharp sheet metal in your attic again. Clean the outside(condenser) coil the same way, SHUT THE BREAKERS OFF OR PULL THE SERVICE DISCONNECT BEFORE YOU CLEAN THE CONDENSER COIL. You will not like the new hairstyle that 240 volts can give you. Hose the condenser coil off spraying inside-out if you can, let it dry a bit, then reenergize the circuits. You might also find a commercial coil cleaner that is sold as a concentrate that you put into a pump-type garden sprayer. That'll do fine, as well. Some of these cleaners contain mild acids, so use them with care. Hope that helps!
Reply With Quote
  #7 (permalink)  
Old 04-20-2006, 12:34 AM
New Member
 
Join Date: Apr 2006
Location: the woodlands,texas
Posts: 4
teecee is on a distinguished road
teecee

Thank you for your response.Please allow me to further explain my situation.
The entire system is well over 20 years old.We have a contract with AHS
(American Home Shield) and on friday they sent their contractor out to replace
a burned out fan motor in the outside compressor unit.We paid the $55.00 service fee and the installer strongly advised us to have the "A" coil and
blower chemically cleaned.(thus the $500.00 plus estimate).The a/c worked
fine until monday 4/17. Today 4/19 AHS sent their man out who replaced a
burned out compressor. This new guy took a look at the "A" coil inside the
house and also said it was very dirty and needed cleaning to get the greatest
benefit from my a/c. My service agreement with AHS stipulates that any item
that would normally be covered must show no sign of neglect on our part and
in other words, if for instance the compressor should fail they would not be
obliged to replace it unless I show proof that the coil etc. was cleaned prior
to the failure.
Several years ago when we felt the a/c wasn't cooling sufficiently,a friend
suggested I purchase a certain chemical spray and with all power turned off,
I sprayed this foamy stuff all over the blower and coil and allow it to soak in
and run off. It worked amazingly well.Now I can't remember what it was or
where I purchased it.I would appreciate any info on this that you or anyone
else can provide.Thank you for taking the time to help.
Reply With Quote
  #8 (permalink)  
Old 04-20-2006, 12:40 AM
Handyman
 
Join Date: Apr 2006
Location: Roanoke, Texas
Posts: 24
skintdigit is on a distinguished road
Teecee, trot on down to your local hardware store or home improvement center, go to the aisle with furnace filters, look around a bit, you'll find the coil cleaner. Ask a salesperson if you can't locate it.
Reply With Quote
  #9 (permalink)  
Old 04-20-2006, 12:42 AM
Handyman
 
Join Date: Apr 2006
Location: Roanoke, Texas
Posts: 24
skintdigit is on a distinguished road
Oh, and don't bother with cleaning the blower in the air handler, it's probably fine, concentrate on the evaporator coil(the A coil).
Reply With Quote
  #10 (permalink)  
Old 04-20-2006, 12:44 AM
New Member
 
Join Date: Apr 2006
Location: the woodlands,texas
Posts: 4
teecee is on a distinguished road
skintdigit...Thank you so much...You have been very helpful.Tomorrow I"m
going to start with Home Depot and go from there.
Best Wishes,teecee
Reply With Quote
Reply

Bookmarks



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

» Stats
Members: 10,228
Threads: 6,830
Posts: 28,263
Top Poster: HayZee518 (3,887)
Welcome to our newest member, sistos
» Links

» Online Users: 47
0 members and 47 guests
No Members online
Most users ever online was 388, 07-01-2007 at 02:54 AM.
Powered by vBadvanced CMPS v3.0.1

All times are GMT -5. The time now is 09:51 PM.


A vBSkinworks Design
Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.1.0