Remember Me?
Home
Forum
New Posts
FAQ
Community
Groups
Albums
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Blogs
Find A PRO
Gallery
Album Gallery
Picture Gallery
Advanced Search
Member List
wjcroft
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Profile Information
wjcroft
New Member
Find latest posts
Find latest started threads
View Articles
View Blog Entries
Mini Statistics
Join Date
11-19-2018
Last Activity
02-06-2019
08:15 PM
Blog Entries
0
More
1
Friend
hawkins111
Recent Visitors
This page has had
2,018
visits
Tab Content
wjcroft's Activity
About Me
Friends
Tab Content
All
wjcroft
Friends
Photos
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
02-10-2019,
12:23 PM
hawkins111
started a thread
Laser 560 no longer made
in
Toyo Heaters
Early this year Toyotomi announced the Laser 560 will no longer be produced. They stated the Laser 560 was only made in the USA and dies for...
see more
0 replies | 35 view(s)
02-07-2019,
11:58 AM
hawkins111
replied to a thread
422 yellow after Rebuild
in
Monitor Heaters
All Monitor 422 units have a small damper in the suction case that is held in by a screw. They all also have a second damper in the flex hose. It can...
see more
9 replies | 247 view(s)
02-06-2019,
06:20 PM
hawkins111
replied to a thread
422 yellow after Rebuild
in
Monitor Heaters
You should calibrate the fuel flow on your heater before you go messing with the pump. Use a flame sensor bypass and a calibrated cup to see where...
see more
9 replies | 247 view(s)
02-03-2019,
02:09 PM
hawkins111
replied to a thread
Monitor 2200 repairs
in
Monitor Heaters
Monitor parts are becoming harder to find everyday. It has been since about 2008 since parts have been made for any of the Monitor line. The M2200...
see more
3 replies | 113 view(s)
02-01-2019,
08:01 PM
hawkins111
replied to a thread
Monitor 441 rebuild glue/gasket question
in
Monitor Heaters
Not the igniter itself but the igniter cover and all other gaskets on the chamber. Not alot just a skim on either side. Tom
see more
10 replies | 296 view(s)
02-01-2019,
04:18 PM
hawkins111
replied to a thread
Monitor 441 rebuild glue/gasket question
in
Monitor Heaters
The tube of glue you got with the pot goes on the rope gasket only. Just a little line all the way round. Be ready when you put the glue on, as it...
see more
10 replies | 296 view(s)
01-27-2019,
02:29 PM
hawkins111
replied to a thread
422 works well, but very slight exhaust odor, only at start of each cycle
in
Monitor Heaters
I have installed many Toyostove heaters. Very, very, very seldom is there a problem with a Toyo right out of the box. If there is, it is usually an...
see more
5 replies | 467 view(s)
01-24-2019,
12:21 PM
hawkins111
replied to a thread
Help!! 422 Not Heating Properly
in
Monitor Heaters
You have stated in the past you use the capsule tank. Since you have had to service the constant level valve, I think you need to look at the fuel...
see more
25 replies | 2605 view(s)
01-21-2019,
08:14 PM
hawkins111
replied to a thread
5 year burn chamber rebuild update
in
Monitor Heaters
The other thing you can do to extend the time between overhaul is to cut off the last bend of the flame sensor. That's the last bend that makes the...
see more
11 replies | 2854 view(s)
01-21-2019,
01:27 PM
hawkins111
replied to a thread
422 works well, but very slight exhaust odor, only at start of each cycle
in
Monitor Heaters
I have seen cracks in a M422 heat exchanger but I think that was due to an over heat situtation. You can also find corrosion at the very bottom of...
see more
5 replies | 467 view(s)
01-21-2019,
01:20 PM
hawkins111
replied to a thread
5 year burn chamber rebuild update
in
Monitor Heaters
In the last years of my stove business I would use burner mat cement to make the seam on the M422 burner ring smooth. I did have some success with...
see more
11 replies | 2854 view(s)
More Activity
No More Results
No Recent Activity
About wjcroft
Basic Information
About wjcroft
Biography:
William J. Croft, biofeedback engineering
Location:
Mount Shasta, CA
Interests:
neurofeedback, biofeedback, mentoring
Occupation:
engineer and developer
Contact
This Page
http://www.homerepairforum.com/forum/member.php?u=36748&s=46aabb61d45d453b3e3bf834c03d9475
Statistics
Total Posts
Total Posts
6
Posts Per Day
0.06
Total Thanks
Total Thanks
55
2 Posts
Find all thanked posts by wjcroft
Find all posts thanked by wjcroft
General Information
Last Activity
02-06-2019
08:15 PM
Join Date
11-19-2018
Referrals
0
Home Page
http://lightfield.com/nf.htm
1
Friend
hawkins111
Journeyman
Showing Friends 1 to 1 of 1