expansion tank

[jnaas2]

The pressure in the tank is suppose to be a few pounds less than the cut in pressure on the pump control. If you have a pressure control that turns the pump on at 40 pounds then the pressure in the tank should be set at 38 psi. Some manafactures want the expansion tank at least 18 inches away from the water heater

[hidden 1]

hey..i found out the change in spike was a teed in- stand alone - seperate line off the main going to washer before main incoming entered home.
I set regulator on 55 and expansion tank on 45-is that a good set?

I now have to mini regulate that single incoming line -stright to washer cold..Can i use a inline pressure relief valve(brv- by watts) betwen outlet/connection and hose exiting to drain -right there? if so what psi setting?Also would a washer arrestor help cushon the line off/ons and expansionduring the wash cycle?

Any suggestions are appreciated

[jnaas2]

At what pressure does your pump turn on and at what pressure does it shut off at. And If they put a tee in the water line out side before it enters the house and connects to the pressure tank that could cause water hammer in the line just from the water going out to the tee and then when the pump comes on it reverses direction back to the pressure tank. A quick closing valve like the kind on a washer will also cause water hammer and you will probably need to install an arrestor on the washing machine cold water line to help stop the water hammer

[hidden 1]

Hi
the teed line (-before main line in -that is regulated)-goes straight to washer spicket and reads around 80 psi with some jumps to 110-120 on both needles.

- it is electric water heater and is set at 110degrees and is 50 gallon. 55psi inline ,tank 45 .

[HayZee518]

put a pressure regulator in your cold water line.

[hidden 1]

aready got one on main line..id rather t off of it before water heater...but its not effecting much as long as its off on that line is it.its 80 at meter so im told

[jnaas2]

The pressure regulator should keep the water pressure that enters the house around 60 psi, run the water for a minute and see what the pressure is while the water is running and then see what the pressure is when no water is being used. If it stays around 60 and then slowly starts to climb the pressure regulator will probably need to be replaced, the spikes you are seeing are probably being caused by water hammering in the water lines which can lead to damaged water lines and fixtures

[rogercollins]

Originally Posted by HayZee518

yeah there's an air space inside whether up or down.

I agree with the above mentioned post. I think you can go with it. Distant from it I would like to share a piece of information with you regarding improvement of your home and hiring the best people for it. It has completely become easy now to hire a contractor to work for your home. There is a service jobtrio.com available online where you can get to know a company before you hires them to work on your home. They provide plumbers, painters and landscapers. They help you to find out the contractor who exactly matches your needs. Hence leaf through the mentioned link to make improvement at your home.

[hidden 1]

thanks but i do my own and have leads if i cant.
I will tap into main line after regulator- for the teeed single line thats not regulated- and cap that line( single high line- un regulated) off...

regulator is working great also to all lines-after it-
ill set it to 55 and tank 53.

[Redwood]

I precharge expansion tanks to the working pressure of the system.