Search:

if yougo to ereplacementparts dot com and type in your washer number then zoom into xontrols schematic you will find item 6 control and timer $375.

check the wiremold company for a round ceiling box. you may need to modify the round box to fit your track lighting track itself.

have your water checked for high concentrations of chlorine. chlrine reacts with the copper to form a blue hue.

you'd be better off installing a four wire pigtail and connecting it to a four wire receptacle. the plug has isolated neutral and earth ground terminals same as in the panelbox either the main or...

72 now and with a pacemaker. They say I have 9 1/2 yers left on this battery.

no more than 60 watts per bulb.

Plumber's putty has always been the mainstay of any drain installation. It remains pliable for ages. Once silicone cures and the fixtures are moved it leaks.

tub is poly with silicone. have to replace tub. nothing will stick to it. using a screw and a nut will imbalance the tub.

your restrictions indicate you can't upload items yet. too short of a membership time. this will change.

Some induction motors have a thick copper shunt wire embedded with the laminations. This is to lessen the "eddy" currents set up when current is applied. If tghe wire is broken the lamination s will...

Go to mcmaster-carr industrial supply. You can find most anything here.

is anything obstructing the up/low limit switch? something on the lead screw or chain?

check the heating pad. there should be something printed on it. look for watts. divide watts by 120 to get amps. but watts is what's measured on a house meter.

look on the nameplate. should be a quantity and type of refrigerant stamped into the nameplate. R-134a you can handle. R-12 and R-22 are authorized only by an epa rated technician.

The magnetic contactor for the blower and or compressor can be outdoors. The control circuit for the contactor is 24 volts. the movable part of the contactor is called the armature, the fixed part...

It wouldn't have a dc line out but a direct connection from the generator to the battery via a regulator circuit. You can have multiple windings on the stator besides the 120/240 for house power.

Any panelbox may serve as a main panel housing a main breaker and branch circuit breakers. a sub panel is a similar panelbox minus a main breaker. Its terminations are usually just main line lugs. ...

PEERLESS old style.

Kohler seems tohave the same or larger footprint.

drill some small holes in the side rails opposite each other. Straighten out some clothes hangers and insert the wires into the holes forming a sort of grid. If the blower suction is too great the...

The solar array puts out raw power but I would think there was a regulator item to regulate the charge going into the battery. Doesn't the generator have a dc output for the battery? Would seem so,...

Piers and Jackposts should be on a solid footing not just an angled base (which yours shows) Dig a hole about a foot deep, 12X12. When it's cured (wait a couple of weeks) then install your posts. If...

when wiring any "distance" from a house, say a well pump, look at the nameplate for amperage or watts. you'll have to calculate for amps. take the power in watts and divide it by voltage to get amps....

As a rule most if not all kitchen circuits should be 20 amp. Lighting is generally 15 amp. Most houses now-a-days are all wired with 12 gauge wire.

the newer types of adhesives should be looked into. Older stuff was latex or water based. A solvent based adhesive evaporates the vehicle faster than a latex, even though water based seeems to dry...