Search:

Search: Search took 1.00 seconds.

  1. Thread: E01

    by msearcher
    Replies
    9
    Views
    4,353

    Main board was the issue. Switched it and...

    Main board was the issue. Switched it and issuexwent away.
  2. Replies
    5
    Views
    2,993

    I can tell you that the main board was bad on a...

    I can tell you that the main board was bad on a 422 heater that the igniter was good and would not work. A relay was bad.
  3. Replies
    5
    Views
    2,993

    Could be the transformer, I have both a...

    Could be the transformer, I have both a transformer and main board on eBay.
  4. Sticky: I do have Jimmyj55 information, tried to post...

    I do have Jimmyj55 information, tried to post twice but it did not take?
  5. Sticky: I believe i eve I have this information saved,...

    I believe i eve I have this information saved, will look for it and post if found.
  6. Replies
    7
    Views
    1,922

    We all thank you for your help on the business...

    We all thank you for your help on the business that was replying to every question
  7. Replies
    7
    Views
    1,922

    This is a forum and not a source for new...

    This is a forum and not a source for new business, I take offense at your replying to everyone's questions as sales leads!
  8. Replies
    3
    Views
    1,094

    Bearings

    I have done a few 2400 bearings and they are a bit more work. Be careful of the small magneti - don't break it and the rivets do have drilled and a lot of prying to get the case apart but it can be...
  9. Replies
    14
    Views
    3,813

    Damper O-ring

    When your working on the combustion motor bearings be sure and take a few more minutes and remove the damper and replace the damper o-ring. It would be a
    shame while your that far into it not to...
  10. I have seen this happen on a 441 that I was...

    I have seen this happen on a 441 that I was working on, turned out to be the damper. I adjusted it and works fine now. Seemed that most of the time it went to high the damper would be stuck and...
Results 1 to 10 of 10