Search:

Type: Posts; User: woodauger; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    0
    Views
    36

    Toyo flue pipe applications

    My bad - sorry. The retailer misidentified what Toyotomi included with the heater. It worked fine with the included fitting. Im putting in an L-300 tomorrow, and wondering if the Laser 30 flue...
  2. Replies
    3
    Views
    536

    Thanks, Tom. I recall a previous post where you...

    Thanks, Tom. I recall a previous post where you went with a 530. I keep a similar selection of Monitor parts next to my kitchen table, and also went with the regulator/UPS (36 hours). The extra...
  3. Replies
    3
    Views
    536

    Monitor 2200 repairs

    Thanks to those who have helped me with my 422 heaters. Iím exploring alternatives, as the components are aging. My garage M2400 runs great. It gets little use, so I have no repair history for this...
  4. Replies
    2
    Views
    1,285

    Thanks for the reply, i should have been more...

    Thanks for the reply, i should have been more patient. It straightened out by itself and burns perfectly. Now back to the firewood pile
  5. Replies
    2
    Views
    1,285

    M422 yellow start

    I just renewed a 422 burner pot with advice from this site, including mat and gaskets. The ring was in good shape and reused. The heater starts horribly, witb yellow-blue around the flame ring, and a...
  6. Replies
    4
    Views
    1,671

    My bad. I reread, and see that the bearings are...

    My bad. I reread, and see that the bearings are for the newer motor (okay, as I have one of those also). Thanks again
  7. Replies
    4
    Views
    1,671

    Hi Tom, i ordered the bearings after reading one...

    Hi Tom, i ordered the bearings after reading one of your older forum posts, and assumed they should be 625zz that you quoted. Are the motors with oil plugs the older syle, or the newer? After...
  8. Replies
    4
    Views
    1,671

    Mid-winter howl (combustion)

    Iíve ordered new bearings for the 422, and after taking the small cooling fan off the combustion motor I find a third rubber lube cap on the face of the bearing cap. It appears to have been full of...
  9. Replies
    9
    Views
    2,106

    The 'I'm stupid' light is lit above my head. I...

    The 'I'm stupid' light is lit above my head. I lubricated through the temperature reset plate opening on the side of the heater, and missed the second bearing cap on the back of the motor. all better...
  10. Replies
    9
    Views
    2,106

    Thanks Tom. I checked my other heater, the fan...

    Thanks Tom. I checked my other heater, the fan turns by hand much easier than the slow one. Better now than in January. Is the motor exclusive to Monitor? If so, i have a dealer about 60 miles from...
  11. Replies
    9
    Views
    2,106

    422 combustion motor starts very slowly

    The air intake is clear, the heater runs well after some initial yellow during startup. The combustion fan hums and runs quite slowly for the first two minutes, before getting up to speed. It is...
  12. Replies
    3
    Views
    1,270

    Thanks for the quick reply, Tom. As the springs...

    Thanks for the quick reply, Tom. As the springs appeared identical, i only switched their positions - hoping that one had become worn - and reinstalled. Noise gone, heater working great
  13. Replies
    3
    Views
    1,270

    Taisan fuel pump

    The house is warm thanks to two 422's, but the one where I sleep got noisy. The solenoid pump made a chirp that sounded like an overstretched spring. I replaced the top part (not the sump) with a...
  14. Thanks Tom - I had forgotton the final fitting in...

    Thanks Tom - I had forgotton the final fitting in the heater is a female, as it's out of sight in the garage. The flue pieces I purchased contained exacty what I needed, and I notice the seller posts...
  15. Flue pipe components, dealer replies welcome

    I'm trying an interior wall installation, flue length 48" with two 90's. I found an ebay seller who deals Monitor and Toyo parts, and he used my sketch to send a 'plug and play' flue extension....
  16. Replies
    1
    Views
    1,179

    422 fan stays on

    The circulation fan runs at a very slow speed so long as the heater is plugged in, even when switched to 'off' and cold. The speed is obviously slower than either of the heater's design speeds. The...
  17. Replies
    4
    Views
    2,918

    Monitor and my homeowner's insurance

    Brief question of the community : has anyone raised eyebrows at their insurer's office when asking about installing a Monitor? I mistakenly mentioned the word "kerosene", and the place (state farm)...
  18. Replies
    2
    Views
    1,870

    Hi, if you can make the time, I need the 422...

    Hi, if you can make the time, I need the 422 service manual also. Gmoor@enter.net is my address. Thanks, Gary
  19. Replies
    10
    Views
    3,778

    I hope the weather favors your trip. Yes, the...

    I hope the weather favors your trip. Yes, the M422 fan. It ran fine as a temporary workshop furnace last year. Still runs great, but the fan is always on low after the unit cools. The fan starts when...
  20. Replies
    10
    Views
    3,778

    I appreciate the reply, Tom. It ran so well all...

    I appreciate the reply, Tom. It ran so well all winter until the last week - but I took your advice and added and replaced it with a second 422 . I tried to download a pdf service manual online, but...
  21. Replies
    10
    Views
    3,778

    clogged Monitor 30

    Thanks HayZee - The heater is a real mess - and it did a fine job until the failure. I got a heads-up from National Grid (my power provider), a couple weeks ago. They were cutting off power to the NY...
  22. Replies
    10
    Views
    3,778

    Efficiency too high for temperature?

    Hi. I'm back begging again. Ran the Monitor 30 all winter in Tug Hill NY region. I left it at 53F Maintenance temperature as I'm still moving in. I spent a few days there in Feb, the outdoor temp...
  23. Replies
    7
    Views
    1,379

    Thanks again to Tom. The calibration instructions...

    Thanks again to Tom. The calibration instructions brought the thermostat right into line. Now if I can figure out how to get the three feet of predicted snow off of my roof....
  24. Replies
    7
    Views
    1,379

    Thank you, Tom

    It's made a huge difference in my home's comfort, enabling me to leave the whole-house dinosaur turned off. I have a 422 backup, but the 30 is running so well I hesitate to fix what isn't broken. Gary
  25. Replies
    7
    Views
    1,379

    Thanks, HayZee

    I don't know the 'economy plus' option - was this on the older Monitor's? The heater does a great job at maintaining 68.5 - but it's set at 55. I'd like to be able to leave the house at 45 if I'm...
Results 1 to 25 of 29
Page 1 of 2 1 2