Search:

Type: Posts; User: paul52446m; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds; generated 43 minute(s) ago.

  1. Replies
    2
    Views
    1,650

    Change out the circuit board. Paul

    Change out the circuit board. Paul
  2. Replies
    12
    Views
    4,765

    When i change out a compressor i order new ones...

    When i change out a compressor i order new ones in and change them. They are Compressor mounts. Paul
  3. Replies
    12
    Views
    4,765

    It sounds like the comp. noise. Check the rubber...

    It sounds like the comp. noise. Check the rubber mounts that the comp. is bolted down with. They are a special rubber mount so the comp. doe's not hit any other metal.
    If you want to check the...
  4. Replies
    12
    Views
    4,765

    Does this unit use R22 Or 410 gas? Did they...

    Does this unit use R22 Or 410 gas?
    Did they amp. check the unit?
    Has the unit loss gas and had to be recharged lately?
    It sounds like the comp. is going bad. Paul
  5. Replies
    5
    Views
    2,075

    Paul Morford

    Thanks, Paul
  6. Replies
    5
    Views
    2,075

    Paul Morford

    I don't know where to put this so i will put it here. I do not like to listen to adds, or music when i am trying to read a thread. Paul
  7. Replies
    5
    Views
    6,217

    White from motor to one pole, White from power...

    White from motor to one pole, White from power supply to that same pole.
    Brown from motor to the other pole.
    Black goes to to switch on contactor. Paul
  8. Replies
    15
    Views
    20,386

    You and lazy pup are way off base. The unit will...

    You and lazy pup are way off base. The unit will have a 10 to 15 amp fuse.
    The 5 amp fuse that the OP is talking about is on the electronic board and it is used to protect the 24 volt only. In...
  9. Replies
    6
    Views
    1,919

    Some of these WH come with small flapper type...

    Some of these WH come with small flapper type check valves in the top of them.
    At least that's what it looks like to me. Might be so it won't gravity flow?
    Any way they look like they are so...
  10. Replies
    9
    Views
    1,897

    I am 65 yr,s old and there has been a lot of...

    I am 65 yr,s old and there has been a lot of changes over the years going from
    pictorial wiring diagrams to somatic, to ladder. I know when i trained my service
    man ten years ago, the most...
  11. Replies
    17
    Views
    5,402

    Keeping simple theory would be going down to the...

    Keeping simple theory would be going down to the hard ware store and buying a simple pressure gauge It would not be popping off on hi temp in three valves in a row. So all he needs to do is check...
  12. Replies
    17
    Views
    5,402

    I am assuming you are on city water? Did you put...

    I am assuming you are on city water? Did you put that booster pump just after the main comes into the house and after the water goes through the filter. Your city pressure is low so when the pump...
  13. Replies
    16
    Views
    6,140

    If there was a tapping in the bottom or low in...

    If there was a tapping in the bottom or low in the end you would see a 1/2 in
    pipe plug sticking out. Your supply and return go down through the top.
    I can't believe they don't any provision for...
  14. Replies
    16
    Views
    6,140

    If it is leaning away from the out let, is there...

    If it is leaning away from the out let, is there a tapping at the other end or in the bottom to let water out. If water lays in the bottom of the tank it will rust it out. Paul
  15. Replies
    16
    Views
    6,140

    I am a heating dealer and if it was mine i would...

    I am a heating dealer and if it was mine i would not get inspectors involved.
    If you only have one tapping out of the tank on the end near the bottom, then
    i would slop the tank to the out let...
  16. Thread: Bryant SE-G

    by paul52446m
    Replies
    1
    Views
    2,636

    You would have to put the wiring diagram on here...

    You would have to put the wiring diagram on here and maybe some pic of the control. You can check to see if you have 24 volts at the gas valve. If you do and the valve does not open then you have a...
  17. Replies
    4
    Views
    1,690

    As far as i know, there is no code that says you...

    As far as i know, there is no code that says you can't put it higher, as long as you build a good base to support it. The relief valve pipe should come down with in 6" of the New floor and so it can...
  18. Replies
    7
    Views
    3,042

    Don't know about where you live, but in my area a...

    Don't know about where you live, but in my area a believe it is against the law to have drain that goes into the ground. They don't want oil , gas and antifreeze
    going into the ground. Even if they...
  19. I think most of these people have air to air heat...

    I think most of these people have air to air heat pump. No water use in a air to air heat pump. Its just a air con. with a reversing valve, so the evaporator becomes the condenser. Paul
  20. If yo go with a 95% furnace, you can get 10 year...

    If yo go with a 95% furnace, you can get 10 year on all parts, life time on heat ex changer. I sell Goodman and have good luck with them. I have never sold a heat pump, you could not give me a heat...
  21. There are a lot of HVAC co. out there that will...

    There are a lot of HVAC co. out there that will take you, I know because i am a HVAC dealer. When you people move into a new area, by all means talk to other people and check these co. out before you...
  22. Turn off boiler, turn off valve going to tank,...

    Turn off boiler, turn off valve going to tank, unscrew tank to get water out, pump 12 lbs of air into tank, re install tank, open valve. Run boiler with out burner on so temp goes down to 80 degrees....
  23. Turn off boiler, turn off valve going to tank,...

    Turn off boiler, turn off valve going to tank, unscrew tank to get water out, pump 12 lbs of air into tank, re install tank, open valve. Run boiler with out burner on so temp goes down to 80 degrees....
  24. The sulfur smell is what you get when the rod in...

    The sulfur smell is what you get when the rod in your water heater does bad.
    When you get a glass of hot water do you smell it there? Do you have a humidifier on you furnace? Also you have drain...
  25. Replies
    7
    Views
    3,463

    Makes you feel old? I can remember when i had a...

    Makes you feel old? I can remember when i had a growler on my bench, when i was running a gas station in the 1960. That was a while ago. Paul
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4