Announcement

Collapse
No announcement yet.

Monitor 30 or 20 solenoid valves.

Collapse

Forum Top GA Ad Widget

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Monitor 30 or 20 solenoid valves.

    i have two monitor M20s and I need the two solenoid valves that are in line the after the pump system going into the burner pot. I was informed that the 30 has the same inline valves. If anyone knows where I can get new or used solenoid valves it would be greatly appreciated. thanks, Jim

  • #2
    You seem to be talking about the Safety Solenoid. Yes the solenoids for M20 and M30 are the same. The safety solenoid has a Ohm value of 1700Ohms and a voltage of 105DC at the board. The safety solenoid part number is 4030.

    How much trouble shooting have you done on them? There is no pump on either of those heaters. The fuel gravity feeds into the burner.

    Comment


    • #3
      I thought mine were bad and I took them apart and put them back together and they started working. I think ebay may have had a set a while back. Check there.

      Comment

      Working...
      X
      =