Results 1 to 2 of 2

Thread: Monitor 441 Heater temperature cuts back

  1. #1
    Join Date
    Oct 2012
    Thanks {vb:rawphrase post_thanks_given 
     Thanks Received 
    Thanked in
    1 Post

    Monitor 441 Heater temperature cuts back

    The below incident has been three days in a row now.
    I had our Monitor 441 Heater set to 74 degrees. Out of no where the set temperature on Monitor dropped back to 70 degrees without us doing anything. I re-established the set temperature to 74 degrees. After approximately 5-7 minutes it did the.same thing.
    I powered off the Monitor, unplugged the unit for about 10 seconds. I then plugged up the Monitor, powered it back on and it works as normal.
    Could someone please offer any suggestions as to what could be causing this condition?

  2. The Following User Says Thank You to rfreely For This Useful Post:

    cboymaine (11-30-2019)

  3. #2
    Join Date
    Mar 2010
    Bethel, Alaska
    Thanks {vb:rawphrase post_thanks_given 
    Thanks Thanks Received 
    Thanked in
    117 Posts
    Loose wiring harness connection for indicator board or Reset Thermostat.
    Last edited by hawkins111; 11-11-2019 at 02:31 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts